Bearing

Help · Install

Install on Keepsake

Keepsake writes the line for you: paste your site's identifier in its settings. For a Page shown on its own domain.

  1. Your Keepsake Page must be shown on its own domain. In Keepsake, open Settings, then Domain: the card Address of your Keepsake Page says so. A Page at keepsake.place/@name cannot be measured with a Bearing site of your own.
  2. In Bearing, add a site with exactly that domain, for example notes.example.com.
  3. Copy this site's identifier:
YOUR_SITE_ID
  1. In Keepsake, open Settings, then Domain. In the card Audience measurement for your Page, paste it in Site identifier and click Connect.

Keepsake then writes Bearing's line on every page of your Page, and sends three events by itself: subscribe (someone subscribes to your letter), outbound-click and share. Your own visits are not counted when you open your Page from Keepsake. To make subscriptions your goal, click Choose this goal in the same card.

Check that it works

Open your site in a new tab. In Bearing, the Installation page of your site shows “Bearing receives visits” within a few seconds. If nothing comes after a minute, see Get started.